Heat pump with radiators or warm-air heating

Short answer

A heat pump works best with water at a low temperature. Many houses with ordinary radiators are fine if they stay warm with water of 45 to 55 °C, which you can test with your current boiler. With warm-air heating (luchtverwarming) a heat pump is possible too, but it needs a specific solution and a calculation for your house.

Why the temperature matters

The lower the water temperature the heat pump has to make, the less power it uses per unit of heat. Owners with floor heating report a COP of 3 to 3.5 in frost and 4 to 4.5 above 7 °C: one kWh of power gives 3 to 4.5 kWh of heat. These are owners' reports, not lab tests.

Test your house with your boiler

Set the flow temperature of your gas boiler to 45 to 55 °C for a winter. If the house stays warm on cold days, the radiators and the insulation are probably good enough for a heat pump. If some rooms stay cold, write them down.

Ordinary radiators

A radiator gives less heat at a lower water temperature. Rooms that stayed cold in the test often need a larger radiator. Ask the installer for a heat-loss calculation per room, and check that the power on the quote matches the heat loss of the house.

Warm-air heating (luchtverwarming)

Many homes from the 1970s and 1980s heat with warm air through ducts. There are two routes: a heat pump that heats water for a water coil in the air heater, or air-to-air units that heat rooms directly. Owners report that air-to-air heating works well above about 0 °C and needs a backup on frosty days. We have no field data yet on heat pumps with warm-air heating, so ask for a calculation for your house.

Settings matter

Owners often find the factory settings too high, for example a heating curve (stooklijn) that asks for water of 55 °C when 35 °C would do. One owner's bill was one and a half times higher until the settings were fixed. Ask the installer to set the heating curve for your house, and check it again after the first cold weeks.

Questions people ask

Does a heat pump work with ordinary radiators?

Often it does, if the house stays warm with water of 45 to 55 °C. Test it with your current boiler for a winter.

Can I use a heat pump with warm-air heating?

Yes, with a water coil in the air heater or with air-to-air units. Owners report that air-to-air heating works well above about 0 °C and needs a backup on frosty days.

Do I need floor heating for a heat pump?

No. Floor heating helps because it works at a low temperature, but many houses with radiators are fine. The test with your boiler shows it.

Sources and dates

  • Owner reports on Reddit (our analysis): measured round trip in daily use and practical experience with heat pumps; community evidence, weighed below tests and datasheets (1 October 2026)

How we use these sources: How we calculate. All headline figures in one place: benchmark data.

Have a quote?

Check whether your quote adds up: the price, the capacity and the promised savings, against our own calculation. It is free, and we take no money from installers or suppliers.

Check your quote

No quote yet? Fill in your own figures in the check, or look at an example result first.